Strong Floor-Mate 80E Owner's Manual page 13

Close the door or replace the plug. Open the mixer door and allow the water to flow into the
pump hopper. Engage the pump. After running the pump for several seconds disengage the
pump and reverse to relieve hose pressure. Disconnect the hose. Wet a rag or sponge and place
into the hose. Reconnect the hose. Engage the pump. Watch for the rag or sponge to discharge.
Disengage the pump and relieve the hose pressure. Repeat the process until clean water exits the
hose.
Clean off all remaining contaminates from the material hose and machine. Shut off power
supply. Grease all fittings according to the maintenance schedule. It is essential that greasing be
done at the end of the day or job to flush out any cement or gypsum that may have entered the
bearings or packing.
After mixer and pump cleanup, disconnect the power supply and lock it out. At this time, the
mixer grate may be removed and thoroughly cleaned. Upon completion of mixer grate cleanup,
replace the grate insuring proper installation and location so the safety switch operates properly.
If the safely switch on the mixer is operating properly, the engine will be shut off it the mixer
grate is removed.
Drain the water from the hoses, especially during freezing temperatures. Drain all water from
tank and water hoses or fittings. Secure all guards to prevent loss during transport. The machine
should now be ready for transporting.
13