Operation - Strong Floor-Mate 80E Owner's Manual

Operation

Before operating this machine, be sure you have read and understand the operation and
safety sections of this manual. Be sure all guards are in place and all services have been
performed.
The Floor-Mate 80E is a multi-purpose machine when equipped with optional components. It
may be used to mix, pump and spray cementitious slurries. The unit consist of a 7.5HP electric
motor that powers the material pump, an electrically driven (1.5 HP) patented double drum
counter-rotating paddle mixer, and 3 options of water system.
To engage the mixer, turn the mixer switch to on. To stop the mixer, turn the mixer switch to off.
The speed of the pump is governed by the speed selector switch (Low, Medium, and High). The
direction of the pump is controlled by the Forward/ Reverse switch. To engage the pump, select
speed and direction then press the green START button. To stop the pump press the red STOP
button. If there is an emergency push the big red EMERGENCY STOP button. When the
emergency is cleared up and everything is safe, twist to release the EMERGENCY BOTTON
and press the reset button. When first starting start the pump on low and increase speed to
desired output speed.
The following sequence should be adhered to when mixing and pumping the first batch. Arrange
material in the area where it will be convenient to add to the mixer. Connect power source;
standard for this machine is 230V single Phase 30A (if mixer is separate from panel, mixer will
require 120V 20A). Connect material hose to pump and water hose to water supply. Bring water
into the mixer. Run mixer to ensure proper rotation (up in the middle) and to wet the mixer.
Open mixer door and allow water into the hopper. Set pump to LOW and Forward, with water in
hopper, push start button to engage pump. Once rotor is spinning pump out the remaining water.
Disconnect the hose and walk the water out of the lines. It may be advantageous to pump a
preliminary batch through the pump before pumping the specified materials. A slurry of cement
or gypsum and water can be used. It can be mixed in the mixer or in a bucket by hand (one bag
is sufficient). Pump the slurry into the hose and follow with the material to be pumped. If the
gypsum is used, it must be of a type that will not flash set.
Add the amount of water required for the size batch to be mixed. Add the aggregate slowly to
prevent the possibility of locking up the mixer.
11