Installation Instructions; Before You Begin; For Your Safety; California Safe Drinking Water And Toxic Enforcement Act - GE Profile Harmony DPGT750ECPL Owner's Manual And Installation Instructions

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT
•
local electrical inspector's use.
IMPORTANT
•
codes and ordinances.
• Install the clothes dryer according to the
manufacturer's instructions and local codes.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Clothes dryer installation must be performed by a
qualified installer.
• This dryer must be exhausted to the outdoors.
• Before the old dryer is removed from service or
discarded, remove the dryer door.
• Service information and the wiring diagram are
located in the control console.
• Do not allow children on or in the appliance.
Close supervision of children is necessary when
the appliance is used near children.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty
• Install the dryer where the temperature is above
50°F for satisfactory operation of the dryer
control system.
• Remove and discard existing plastic or metal foil
duct and replace with UL-listed duct.
CALIFORNIA SAFE DRINKING WATER
AND TOXIC ENFORCEMENT ACT
This act requires the governor of California to
publish a list of substances known to the state to
cause cancer, birth defects or other reproductive
harm and requires businesses to warn customers
of potential exposure to such substances. Gas
appliances can cause minor exposure to four of
these substances, namely benzene, carbon
monoxide, formaldehyde and soot, caused
primarily by the incomplete combustion of natural
gas or LP fuels. Properly adjusted dryers will
minimize incomplete combustion. Exposure to
these substances can be minimized further by
properly venting the dryer to the outdoors.
– Save these instructions for
– Observe all governing
.

FOR YOUR SAFETY:

WARNING –
• To reduce the risk of severe injury or death,
follow all installation instructions.
• Clothes dryer installation must be performed
by a qualified installer.
• Install the clothes dryer according to these
instructions and in accordance with local
codes.
• This dryer must be exhausted to the outdoors.
• Use only 4" rigid metal ducting for exhausting
the clothes dryer to the outdoors.
• DO NOT install a clothes dryer with flexible
plastic ducting materials. If flexible metal
(semi-rigid or foil-type) duct is installed, it
must be UL-listed and installed in accordance
with the instructions found in "Connecting the
Dryer to House Vent" on page 29 of this
manual. Flexible ducting materials are known
to collapse, be easily crushed and trap lint.
These conditions will obstruct dryer airflow
and increase the risk of fire.
• Do not install or store this appliance in any
location where it could be exposed to water
and/or weather.
• The National Fuel Gas Code restricts
installations of gas appliances in garages.
They must be 18 inches off the ground and
protected by a barrier from vehicles.
• Save these instructions. (Installers: Be sure to
leave these instructions with the customer.)
FOR GAS MODELS ONLY:
NOTE: Installation and service of this dryer
must be performed by a qualified installer,
service agency or the gas supplier.
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed
plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be T-handle-type.
• A flexible gas connector, when used, must
not exceed 3 feet.
18
Dryer
DPGT750
Risk of Fire