GE Profile Harmony DPGT750ECPL Owner's Manual And Installation Instructions page 39

REMOVE CONTROL BOARD
7
FROM DRYER BACKSPLASH
Remove the four screws holding the control
board to the backsplash. Remove the control
board and set it aside.
Screws
SWITCH BACKSPLASHES
8
Place the backsplash from the dryer on top
of the washer and place the backsplash from
the washer on top of the dryer.
ATTACH DRYER CONTROL
9
BOARD TO NEW BACKSPLASH
Attach the control board to the new
backsplash by replacing the four screws
removed from the control board earlier.
The control board will now be on the
opposite side of the dryer backsplash.
Screws
Installation Instructions
Screws
Screws
39
RECONNECT DRYER CONTROL
10
BOARD
Connect the dryer control board to the new
backsplash by sliding the ribbon connector
on the new backsplash onto the metal pins
on the control board and pushing in. Make
sure the ribbon is not twisted before inserting
the connector.
Place the ribbon and the wire from the rear
cover under the strain relief on the new
backsplash.
ATTACH DRYER BACKSPLASH
11
Insert the tabs on the bottom front of the
backsplash into the slots on the dryer and
rotate the backsplash into place. Secure the
new backsplash to the dryer using the four
screws removed earlier.
Strain Relief