Crosswater US-WF FSBATH Installation Instructions

Waldorf Freestanding
Bath Tub
US-WF_FSBATH
Installation Instructions

Introduction

This bath tub has been fully inspected throughout the production
process and only leaves our factory after a 15 stage QC process.
Carefully remove the bath tub from the box, using the carrying bag
and check that all parts have been supplied.
Before beginning installation of the bath tub please check for any
damage that may have occurred during transport.
Improper installation shall result in loss of warranty in case of damage
caused by impacts or rubbing against rough surfaces.
Prior to installing the bath tub prepare a connection of water inlet/outlet.
Pay attention to leveling of oor where the bath tub will be located,
ensuring it can take the weight of the bath tub and water.
The customer may choose the type and location of the faucets,
installation instructions should be supplied by the faucet manufacturer.
The installation procedure of the bathtub may di
described in the installation instructions, depending on where you
wish the bath tub to be located.
If the surface of the bath tub is wet it may create a risk of slipping
which may increase by using soap, shampoo, oils and similar products.
IMPORTANT: Please read these instructions carefully before you
begin and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.
RECOMMENDATIONS:
It is r
installa
and allows product to be easily removed if required in the future.
It is recommended to remove the protective packaging after
installation of the bath tub.
its height.
It is required to use US-CW15 waste ow products with this
bath tub.
Weight - lbs
Weight with water - 7 lbs

Tools required

Tape
measure
2/3 Height = 5 Gal./2 L
Safety Set
glasses square

Installation notes

NOTES: The installation must comply with all plumbing codes including
local codes and be installed by a licensed plumbing contractor.
Do not remove the old xture before you unpack and inspect the
new bath tub.
Store the bath tub in a safe place until you begin installation to avoid
any damage.
Assemble the bath tub on a mat to protect against damage to the
bath tub surface.
Avoid getting cement, grit, sand or masonry products on to the surface.
Protect and cover the bath tub during installation, other tradesmen
might damage the bath if no precautions are taken.
INSTALLATION: Remember to turn o the water supply before
connecting to any existing pipe work or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric

Dimensions

Weight - 236lbs
Weight with water - 779lbs
3 /
35
64"
19 /
11
16"
Pencil
Ø2 /
3
32"
47 /
9
32"
65 /
17
32"
3 /
15
16"
45 /
43
64"
Spirit Silicone
level sealant