Interface Boards; Scsi Boards; Usb 2.0 Interface Board - Canon DR-3080CII Startup Manual

Interface Boards

An interface board is needed to connect the scanner to your computer. There
are two types of interface boards. These interface boards are described below
with recommendations for manufacturers and models.

SCSI Boards

When connecting the scanner via SCSI, verify that the SCSI board you are
using is one recommended for use with the scanner. The recommended SCSI
boards are as follows:
Recommended SCSI boards
Manufacturer:
Models:
IMPORTANT
When installing the SCSI board in your computer, please refer to the
computer user's guide and follow the instructions provided

USB 2.0 Interface Board

When connecting the scanner via USB, verify that the USB 2.0 interface
board you are using is one recommended for use with the scanner. The
recommended USB 2.0 interface boards are as follows:
Recommended USB 2.0 Interface boards
Manufacturer:
Models:
IMPORTANT
●
When installing the USB 2.0 interface board in your computer, please refer
to the computer user's guide and follow the instructions provided.
●
Make sure that the USB driver is an updated version provided by Adaptec
or Microsoft.
Note
●
The DR-3080CII passed the Hi-Speed USB 2.0 certification test. However,
when you use the scanner with a personal computer equipped with USB 2.0
as standard, the scanner may not always operate normally.
●
If the interface is not Hi-Speed USB 2.0 compatible, the scanning speed
will slow down.
18
Installing the Scanner
Adaptec
AHA-2930U, AHA-2940AU, ASC-19160,
ASC-29160, APA-1480
Adaptec
USB 2 connect 2000LP (AUA-2000)
USB 2 connect 3100 (AUA-3100LP)
USB 2 connect 5100 (AUA-5100)
USB 2 connect for Notebooks (AUA-1420)