Before You Call For Service - GE Triton GSD5900G Owner's Manual

Before you call for service...

Problem Possible Causes
Dishes and flatware Inlet water temperature • Raise the water heater temperature to 120°F.
not clean
is below 120°F
Water pressure is
temporarily low
Air gap is clogged
Improper rack loading
Spots and filming
Extremely hard water
on glasses and
Low inlet water
flatware
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Rinse agent dispenser
empty
Too little detergent
Cloudiness on
Combination of soft
glassware
water and too much
detergent
Water temperature
entering the dishwasher
exceeds 150°F
Yellow or brown film
Tea or coffee stains
on tub
An overall yellow or
brown film can be
caused by iron deposits
in water
White film on inside
Hard water minerals
surfaces
Detergent left in Dishes are blocking the • Reposition the dishes.
dispenser cups detergent cups
Steam This is normal
Black or gray Aluminum utensils have • Remove marks with a mild, abrasive cleaner.
marks on dishes rubbed against dishes
14
What To Do
• Use HI TEMP WASH.
• Turn on a faucet. Is water coming out more slowly than usual?
If so, wait until pressure is normal before using your dishwasher.
• Clean the air gap.
• Make sure large dishware does not block the detergent dispenser or
the wash arms.
• Use Jet-Dry ® or Cascade Rinse Aid
prevent new film buildup.
• To remove stubborn spots and pre-existing film from glassware:
1 Remove all metal utensils from the dishwasher.
2 Do not add detergent.
3 Select the longest cycle.
4 Start the dishwasher and allow to run for 18 to 22 minutes.
Dishwasher will now be in the main wash.
5 Open the door and pour 2 cups (500 ml) of white vinegar into the
bottom of the dishwasher.
6 Close the door and allow to complete the cycle. If vinegar rinse
doesn't work: Repeat as above, except use 1/4 cup (60 ml) of citric
acid crystals instead of vinegar.
• This is called etching and is permanent. To prevent this from
happening, use less detergent if you have soft water. Wash glassware
in the shortest cycle that will get them clean.
• Lower the water heater temperature.
• Remove the stain by hand, using a solution of 1/2 cup bleach and
3 cups warm water.
WARNING
Before cleaning interior, wait at least 20 minutes after a cycle for the
heating element to cool down. Failure to do so can result in burns.
• A special filter in the water supply line is the only way to correct this
problem. Contact a water softener company.
• GE recommends Jet-Dry ®
hard water mineral stains.
• For extreme staining, clean the interior by applying dishwasher
detergent to a damp sponge. Wear rubber gloves. DO NOT use any
type of cleaners other than those recommended or hand dishwashing
detergent because it may cause foaming or sudsing. Cascade
Cascade ® Complete and Electrasol
been approved for all GE dishwashers.
• Steam comes through the vent by the door latch during drying and
when water is being pumped out.
®
rinse agent to remove spots and
or Cascade Rinse Aid ® to help remove some
® Dishwashing Detergents have
,
®