Daikin FTKZ50VVMV Operation Manual page 14

Read Before Operation
Preparation Before Operation
Timer
NOTE
Notes on setting the position where the indoor unit is installed
• The display automatically returns to the default screen after 60 seconds. To return to the default screen sooner, press
• The airflow direction is properly controlled by inputting a number representing the installation position of the indoor unit into the remote controller.
• If you do not set the right corner and left corner correctly, the airflow direction may not be properly controlled in some airflow settings.
• The airflow direction range at the horizontal airflow setting (airflow direction that can be selected with
settings for the installation position.
13
„ To set the position where the indoor unit is installed
Set the indoor unit position to avoid direct airflow to walls.
„ To set
1.
Press
• '' " appears on the LCD.
• '' " (menu number) blinks.
2.
Press or
• '' " appears on the LCD.
• '' " (menu number) blinks.
3.
Press
4.
Press or
position as follows:
¡ Installation position
If the unit is...
In the middle of the
wall (factory default
seting)
≤500 mm from the
wall on right
≤500 mm from the
wall on left
• The airflow range will be adjusted to avoid direct contact with the wall.
5.
Press
• The installation position of the indoor unit will be set.
6.
Press
and hold the button for 2 seconds.
and select menu number
to confirm the selected setting.
and select the indoor unit
Position
LCD
number
Blinks
Blinks
Blinks
again.
to return to the default screen.
Installation position
Centre : The horizontal airflow direction
blows air evenly to the right and left.
Right corner : The horizontal airflow
direction blows air to the left.
Left corner : The horizontal airflow
direction blows air to the right.
Page 17, 18
twice.
) will change according to the
.