Problem and alarm code
The programme does not start.
The appliance does not fill with
water.
•
The lights related to the
programme buttons flash 1
time intermittently.
•
An acoustic signal sounds
intermittently.
The appliance does not drain
the water.
•
The lights related to the
programme buttons flash 2
times intermittently.
•
An acoustic signal sounds
intermittently.
The anti-flood device is on.
•
The lights related to the
programme buttons flash 3
times intermittently.
•
An acoustic signal sounds
intermittently.
Malfunction of the water level
detection sensor.
•
The lights related to the
programme buttons flash 4
times intermittently.
•
An acoustic signal sounds
intermittently.
Malfunction of the wash pump
or the drain pump.
•
The lights related to the
programme buttons flash 5
times intermittently.
•
An acoustic signal sounds
intermittently.
The temperature of the water
inside the appliance is too high
or malfunction of the tempera-
ture sensor occurred.
•
The lights related to the
programme buttons flash 6
times intermittently.
•
An acoustic signal sounds
intermittently.
Possible cause and solution
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the end of
the countdown.
•
The appliance recharges the resin inside the water softener.
The duration of the procedure is approximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the interior filter system is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Close the water tap.
•
Make sure that the appliance is correctly installed.
•
Make sure the baskets are loaded as instructed in the user
manual.
•
Make sure that the filters are clean.
•
Switch the appliance off and on.
•
Switch the appliance off and on.
•
Make sure that the temperature of the inlet water does not ex-
ceed 60°C.
•
Switch the appliance off and on.
19