Product Identification - Toro GROUNDSMASTER 1000L Operator's Manual

3. Refill the engine with 3.8 quarts (3.6 l) of rec-
ommended motor oil. Refer to Changing
Crankcase Oil.
4. Start the engine and run at idle speed for two
minutes.
5. Drain gasoline from the fuel tank, fuel lines,
pump, filter and separator. Flush the fuel tank
with clean solvent and connect all fuel lines.
6. Thoroughly clean and service the air cleaner
assembly.
7. Seal the air cleaner inlet and the exhaust outlet
with weather proof masking tape.
8. Check the oil filler cap and fuel tank cap to
ensure they are securely in place.

PRODUCT IDENTIFICATION

The traction unit has two identification numbers: a
model number and a serial number that are stamped
into a plate. The identification plate is located near
the left brake pedal on the frame (Fig. ). In any cor-
respondence concerning the traction unit, supply the
model and serial numbers to ensure correct informa-
tion and replacement parts are obtained.
To order replacement parts from an Authorized
TORO Distributor supply the following information:
1. Model and serial numbers of the traction unit.
2. Part number, description and quantity of parts
desired.
Note: Do not order by reference number if a parts
catalog is being used; use the part number.
1. Model and serial ID plate
Product Identification
Figure 32
29