Toro GROUNDSMASTER 1000L Operator's Manual page 21

Minimum Recommended Maintenance Intervals
Maintenance Procedure
Check battery fluid level
Check battery cable connections
Lubricate all grease fittings
Lubricate brake cables
Check cutting unit gear box oil level
Clean under cutting unit belt covers
Check cutting unit drive belt adjustment
Change engine oil
Service air filter
Change the engine oil filter
Check electric clutch gap adjustment
Check PTO belt tension
Inspect cooling system hoses
Service air filter
Replace fuel filter
Check rear wheel toe-in and steering linkage
Charge transmission filter
Torque the wheel lug nuts
Drain and clean fuel tank
Replace cutting unit gear box oil
Pack rear wheel bearings
Coat transmission bypass pins with grease
Torque head, adjust valves and check engine RPM
Initial break in at 10 hours
Initial break in at 80 hours
Replace moving hoses
Replace safety switches
Flush the cooling system and replace fluid
Replace hydraulic oil
Maintenance Interval & Service
Every 100
Every 50
hours
hours
Annual Recommendations:
Items are recommended every 1000 hours or
two years, whichever occurs first.
Maintenance
Every
Every
400 hours
200 hours
21