Product Identification - Toro 03602 Operator's Manual

Preparation For Seasonal Storage
Traction Unit
1. Thoroughly clean the traction unit, cutting units
and the engine.
2. Check the tire pressure. Inflate all tires to
103–138 kPa (15–20 psi)
3. Check all fasteners for looseness; tighten as nec-
essary.
4. Grease or oil all grease fittings and pivot points.
Wipe up any excess lubricant.
5. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
6. Service the battery and cables as follows:
a. Remove the battery terminals from the battery
posts.
b. Clean the battery, terminals, and posts with a
wire brush and baking soda solution.
c. Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Toro Part
No. 505-47) or petroleum jelly to prevent cor-
rosion.
d. Slowly recharge the battery every 60 days for
24 hours to prevent lead sulfation of the bat-
tery.
Engine
1. Drain the engine oil from the oil pan and replace
the drain plug.
2. Remove and discard the oil filter. Install a new
oil filter.
3. Refill the oil pan with 5 l (5.3 qt) of SAE 15W—
40 CD motor oil.
28
4. Start the engine and run at idle speed for approxi-
mately two minutes.
5. Stop the engine.
6. Thoroughly drain all fuel from the fuel tank, lines
and the fuel filter/water separator assembly.
7. Flush the fuel tank with fresh, clean diesel fuel.
8. Secure all fuel system fittings.
9. Thoroughly clean and service the air cleaner
assembly.
10. Seal the air cleaner inlet and the exhaust outlet
with weatherproof tape.
11. Check anti-freeze protection and add a 50/50
solution of water and Peugeot recommended anti-
freeze as needed for expected minimum tempera-
ture in your area.

Product Identification

MODEL AND SERIAL NUMBER
The model and serial number is on a plate that is
mounted on the left front frame member. Use model
and serial number in all correspondence and when
ordering parts.