Cluster Setup - Fidelis 10G Quick Start Manual

10. Configure the network parameters for the system and each active network interface.
•
Use the Network Configuration table you prepared earlier.
•
When complete, return to the top menu.
11. When complete, select OK to leave Setup.
12. From command line, reboot the system:
sudo /fss/bin/shutdown.pl --user admin –reboot
13. Repeat steps for all appliances being added to the Collector cluster
14. Use the PING command to verify connectivity between the XAs on their SYNC/eth2
interfaces.

8. Cluster Setup

On the Final Collector XA4 Appliance
If you have not completed setup for the XA4 appliances in section 7 above, or you are adding an
XA4 appliance to the Collector, follow these steps:
1. Login via KVM console.
2. Use these credentials at the login prompt.
immediately:
-
user: fidelis
-
default password: fidelispass
2. Change to root using the default password
3. From the command line, run
/bin/bpctl_start
/bin/bypass_util all set_force_bypass off
4. From the command line, run: /FSS/bin/setup
5. Navigate to Collector Settings.
6. At the XA4 count, enter the number of XA4 appliances, and select Ok.
7. Review the list of IP addresses. Select Confirm if these are correct or select Edit to correct
them.
©Fidelis Cybersecurity
Fidelis Network® High Capacity Collector
You will be required to change the password
9
QUICK START GUIDE
www.fidelissecurity.com