Fidelis 10G Quick Start Manual page 3

Collector Setup Checklist
Check Fidelis Network Sensor – Appliance Requirements
Appropriate rack space, power, and cooling
Rack tools, rails, and connectors
Keyboard and video monitor / KVM switch for temporary appliance setup
Power cables — two per appliance, appropriate for power source and region
Ethernet cables (cat5 and optical) for Admin, DB, SYNC and iLO ports
Network switches with enough physical ports
Optical transceivers for switches
Logical network information: IP addresses, hostnames
For Fidelis Network Software version 9.3.3 and later, the appliance system type
3. Collector: Network Port and Cabling Requirements
Each appliance must be connected to the various networks with appropriate cables and in some
cases, transceivers. The tables below describe the physical connection and cable type associated
with each port on the appliance.
Collector Controller 10G Appliance
Port Label Physical Connection Type (default)
Admin 10GbE LC connector
DB Net 10GbE LC connector
ILO GbE RJ45 (copper)
Figure 3: Network Port Assignments — Collector Controller 10G (Rev-J)
©Fidelis Cybersecurity
Fidelis Network® High Capacity Collector
(Appendix B)
(Section 4)
(Section
Cable Type
Fiber SR Patch Cable, Multimode 850nM
Fiber SR Patch Cable, Multimode 850nM
Cat 5/5e/6 patch cable
3
QUICK START GUIDE
(Section 3)
5, Appendix A)
(Appendix
www.fidelissecurity.com
C)