Edsal WorkForce HR153060 Quick Start Manual

HR153060 4 Shelf HR153060 4 Shelf
HR153060 4 Shelf
Description Qty.
A - Beams 8
B - Braces 8
C - Post 8
D - Woodboard 4
E - Coupler 4

Safety Instructions

Safety Instructions
Safety Instructions
These units should be placed on a level surface. Failure to do so can result in poor product performance or create a
possible safety hazard. This unit should be securely anchored to a wall or floor with suitable fasteners, which are not
included. Do not use this unit for anything other than the manufactures intended purpose. DO NOT STAND ON ANY
PART OF THE UNIT, OR USE IT AS A LADDER. Evenly distribute the weight on each level and always keep the
heavier loads on the bottom. Use care when working with metal parts.

General Instructions

General Instructions General Instructions
Assembly is done with the holes of the beams and braces fitting into the tabs of the post (See "Proper Installation
Techniques For Tab Engagement"). A rubber mallet may be used on the beams and braces to seat the tabs properly.
A hammer can also be used, providing one uses a cloth or a block of wood between the hammer head and the parts to
prevent damage. Tap gently and be sure the tabs are straight and fully engaged.
dling some of the tabs of the post that are used for engaging the beams and braces may
have become closed. Visually inspect all the post. If it is found that some tabs are closed,
use a small tipped screwdriver and from behind the post push the tabs slightly to re-open.
Should you have any comments, damage, missing parts, or problems with assembly of this unit please feel
free to contact our Work Force manufacturing facility at, (773) 475-3000 and request customer service.
We can also be reached on the internet at the following email address : customerservice@edsal.com.
To obtain replacement parts, please provide the following information :
- Model # - Part # & Description
Steel Storage Rack
B - Braces
D- Woodboard Shelf
- - 60"h x 15"d x 30"w 60"h x 15"d x 30"w
- 60"h x 15"d x 30"w
Part Number Part Size
XHBE 2902 29 3/4"
XHBE 1402 14 3/4"
HXPT 3002 30"
RPB 21530 15" x 30"
XHPC 0403 4"
- Location Purchased
A - Beams

Proper Installation Techniques For Tab Engagement

Proper Installation Techniques For Tab Engagement
Proper Installation Techniques For Tab Engagement
B - Partial Engagement
A - Tab Overlay
Brace holes are over Apply downward pressure to
post tabs, and the the brace by hand, to par-
brace is flush to the tially seat the tabs.
post.
Brace Is Flush To Post
Holes Over Tabs
During shipping and han-
- Date Purchased
MODEL NUMBER
HR153060
E - Post Coupler
C - Full Engagement
Tap brace down lightly with
a mallet to properly seat
the tabs.
Downward Hand Pressure
Consumer Products Division
Edsal Manufacturing Company
4400 South Packers Avenue
Chicago, IL 60609
www.edsal.com
C - Post
Tap Lightly