Table of Contents
Advertisement
7 Programming
The KNX IP Interface 740.1 wireless can be programmed by the ETS in various ways.
7.1 Via the KNX bus
For this, the device must only be connected to the KNX bus. The ETS requires an additional
interface (e.g. USB) to the KNX bus. This way, both the individual address and the entire
application including IP configuration can be programmed. Programming via the KNX bus is
recommended if no IP connection can be established.
7.2 Via KNXnet/IP tunneling
No additional interface is required here. Programming via KNXnet/IP tunneling is possible if the
device already has a valid IP configuration (e.g. via DHCP). In this case, the device is displayed in
the interfaces in the ETS and must be selected. The download takes place from the ETS project,
as with other devices.
© 2021 WEINZIERL ENGINEERING GmbH
Seite 12/20
Advertisement
Table of Contents
Need help?
Do you have a question about the KNX IP Interface 740.1 wireless and is the answer not in the manual?
Questions and answers