madVR Labs Envy Setup Manual page 5
Shield & plex setup guide
Hide thumbs
Also See for Envy:
- User manual (21 pages) ,
- Setup manual (11 pages) ,
- Barco setup manual (8 pages)
Advertisement
7. Part 1: Under "Custom Display mode", make sure the "Set to recommended" switch is OFF, as
shown below. Then select "Filter by resolution" and pick "3840x2160", select "Filter by refresh
rate" and pick "23.976 Hz", and select "Filter by color space" and pick "YUV 422 12-bit Rec. 2020".
Part 2: After performing the steps in "Part 1" above, select "Display modes" (at the bottom of the
screen shown above) and select the only option listed (as shown below). Your "Current display
mode", with then update to what you see in the green highlighted box above.
5
Copyright © madVR Labs, LLC. All rights reserved.
Advertisement
