Lamp Replacement - Canon LV-X4 LV-7230 Owner's Manual

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an
end, the LAMP REPLACE indicator lights yellow. If this indicator
lights yellow, replace the lamp with a new one promptly.
CAUTION
Allow a projector to cool, for at least 45 minutes before
you open the Lamp cover. The inside of the projector
can become very hot.
Follow these steps to replace the lamp.
1
Turn off the projector and disconnect the AC plug. Allow the
projector to cool for at least 45 minutes.
2 Loosen the screw with a screwdriver, and remove the lamp
cover.
3 Loosen 2 screws of the lamp with a screwdriver and pull out
the lamp by grasping the handle.
4
Replace the lamp with a new one and tighten the 2 screws
back into position. Make sure that the lamp is set properly.
Replace the lamp cover and tighten the screw.
5
Connect the AC power cord to the projector and turn on the
projector.
6
Reset the Lamp replace counter.
See "Lamp Replace Counter" on the next page .
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
●
Model No. of your projector
●
Replacement Lamp Type No.
50
This indicator lights yellow
when the life of the projection
lamp draws to an end.
CAUTION
For continued safety, replace with a lamp of the same
type. Do not drop a lamp or touch a glass bulb! The
glass can shatter and may cause injury.
Lamp Cover
Lamp
Screw
: LV-X4, LV-7230
: LV-LP21 (for LV-X4)
(610 315 5647)
LV-LP18 (for LV-7230)
(610 309 2706)
Top Control
KEY
STONE
VOL
+
LAMP REPLACE
Screw
Screw
Handle