Battery Installation; Battery Safety Information - Fisher-Price RESCUE HEROES J9555 Manual

Hide thumbs Also See for RESCUE HEROES J9555:
Table of Contents

Advertisement

BATTERY
INSTALLATION
Battery Compartment Door
• Locate the battery compartment door on the inside of the lookout.
• Loosen the screw in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three "AA" (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
• When lights or sounds become faint or stop, it's time for an
adult to change the batteries!
• Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
BATTERY SAfETY
INfORMATION
SHOWn ACtUAL SiZE
1.5V x 3
"AA" (LR6)
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are only
to be charged under adult supervision.
THE COMMAND CENTER
Lookout
1
Leg B
• Position the base on a flat surface.
• Note the A, B, C, and D markings on the legs and the
slots in the base.
• Insert and "snap" leg A into the base slot marked A.
• Insert and "snap" leg B, leg C and leg D into the matching
base slots marked B, C and D.
• Pull up on each leg to be sure each is secure in the base.
2
Label 10
Label 20
• Apply the labels as shown in the illustration.

BUILDING
Leg C
Leg D
C
D
Slots
B
A
Base
Leg A
Label 19
Label 9

Advertisement

Table of Contents
loading

Table of Contents