BUILDING THE COMMAND CENTER
7
Lookout
Tab
Slots
• Position the lookout with the Fisher-Price
• Insert and "snap" the tabs on the lookout into the slots
in the 3rd floor.
8
Square Tab
Upward
Pole
Peg
Downward
Elevator
IMPORTANT! Please take care to follow the next two assembly
steps 8 and 9 carefully. If you do not assemble the elevator
correctly, you will not be able to take it apart and the toy will
not function properly.
• Position the elevator upright on a flat surface.
• Position the pole so that the square tab is upward and
the peg is downward.
• Fit the peg end of the pole into the opening in the elevator.
• Lift the elevator up so that the pole fully inserts into the
elevator, as shown.
Fisher-Price
Logo
®
Tab
Tab
3rd Floor
logo outward.
®
9
Base
• Make sure the elevator footpad is upright, as shown.
• While holding the elevator at the top of the pole, insert and
"snap" the peg end of the pole into the cylinder on the base.
• Release the elevator so it spins down the pole.
Raised Tab
10
®
Tabs
Lookout
• Position the roof so that the raised tab is facing forward.
• Fit the slots in the roof to the archway and lookout tabs.
• Fit the peg on the underside of the roof over the square tab
on the pole.
• Push down on the roof near each tab to secure the roof in
place. Pull up on the roof to be sure it is secure.
™
Footpad
Elevator
Pole
Peg
Cylinder
Roof
Peg
Square
Tab
Pole