Daikin FTXM09VVJU Operation Manual page 29

NOTE
Note on COUNT UP-DOWN ON/OFF TIMER
• After setting, the time displayed on the LCD will automatically count down by 1 hour for every 1 hour that passes.
For example, if the OFF TIMER is set to 3 hours, the display will change as follows: 3hr → 2hr → 1hr → blank (OFF)
Switching between ON/OFF TIMER display modes (24 hour clock and hours remaining display)
• When changing timer display modes (from 24 HOUR ON/OFF TIMER to COUNT UP-DOWN ON/OFF TIMER or vice versa), the timer cancels.
The timer must be set again to activate it.
To use the ON/OFF TIMER with an hours remaining display
\
(COUNT UP-DOWN ON/OFF TIMER)
• Check that the clock is correct. If not, set the clock to the present time.
1.
Press and hold
5 seconds, when the signal indicator ( ) blinks,
release your finger from the button.
For ON TIMER
"
" " blinks.
For OFF TIMER
"
"
• " " and day of the week disappear from the LCD.
2.
Press until the time setting reaches the point you like.
• Each pressing of the button increases or decreases the time setting by 1 hour.
• The time can be set between 1 and 12 hours.
3.
Press
• " " and " ", and setting time appear on the LCD.
• The TIMER lamp lights orange.
• To change the display mode from COUNT UP-DOWN ON/OFF TIMER to 24 HOUR ON/OFF
TIMER, repeat STEP
• Timer display mode cannot be changed while " " or "
Press or
Display
Combining display modes
• Different display modes (24 HOUR ON/OFF TIMER and COUNT UP-DOWN ON/OFF TIMER)
can be used for the ON TIMER and OFF TIMER simultaneously.
(Example)
Present time: 22:00 [unit is operating]
OFF TIMER at 1:00 (3 hours after present time)
ON TIMER at 6:00 (8 hours after present time)
or
" appears on the LCD.
" appears on the LCD.
" blinks.
or again.
1 2
, and continue from STEP
to stop the blinking.
Combined
TIMER Operation
Page 11
for about
of "24 HOUR ON/OFF TIMER".
"are blinking.
Page 26, 27
28