Before Operation - Exmark VIKING 408 Operator's Manual

Table of Contents

Advertisement

Turn clockwise to reset the drive system. Do Not
overtighten.
Tracking Adjustment Knob
Located on the right-hand side of the rear of the fuel
tank support.
The knob can be adjusted so that machine will "track"
straight ahead with the drive levers released.
PTO Engagement Control
Located on left side of control console.
To engage the blades, the knob must be pulled
toward the operator until the turnbuckle (attached
to the blade engagement idler) locks over-center. To
disengage the blades, push the knob down until the
assist arm contacts the pin on the deck.
Park brake must be disengaged before PTO is
engaged or engine must begin shutdown.
Cold Start Kit
Located on the right hand side of engine deck, below
and slightly ahead of the hydro control shield.
The cold start kit is used to ease the starting of the
unit in cold weather or when the unit has not been
operated for a period of time. The cold start kit
moves the idler pulley away from the pump belt,
releasing the tension on the belt which allows the
engine to turn over with less resistance (see Starting
the Engine section in Operation).

Before Operation

Before Operation Safety
• Evaluate the terrain to determine what accessories
and attachments are needed to properly and
safely perform the job. Only use accessories and
attachments approved by Exmark.
• Inspect the area where the machine is to be used
and remove all rocks, toys, sticks, wires, bones,
and other foreign objects. These can be thrown
or interfere with the operation of the machine
and may cause personal injury to the operator or
bystanders.
• This mower was designed for one operator only.
Do Not carry passengers.
• Wear appropriate personal protective equipment
such as safety glasses, long pants, substantial
slip-resistant footwear, and hearing protection.
Tie back long hair and avoid loose clothing and
loose jewelry which may get tangled in moving
parts.
• This machine produces sound levels in excess of
85 dBA at the operator's ear and can cause hearing
loss through extended periods of exposure. Wear
hearing protection when operating this machine.
• Check that the following items are in place and in
proper working condition: the operator presence
controls, safety switches, guards, shields, discharge
deflector and/or the entire grass catcher system.
Do not operate the machine unless they are in
proper working condition. Replace worn or
deteriorated parts with genuine Exmark parts
when necessary.
DANGER
It is essential that operator safety mechanisms
be connected and in proper operating
condition prior to use. Contacting the blade
can result in serious personal injury.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position. When the key is turned to
the "OFF" position, the engine should shut
off and the blade should stop. If not, stop
using the machine immediately and contact
an Authorized Service Dealer.
• Do Not operate the mower when people,
especially children, or pets are in the area. Shut
off the machine and attachment(s) if anyone
enters the area.
• Do Not operate the machine without the entire
grass collection system, discharge deflector,
or other safety devices in place and in proper
working condition. Grass catcher components
are subject to wear, damage and deterioration,
which could expose moving parts or allow objects
to be thrown. Frequently check for worn or
deteriorating components and replace them with
the manufacturer's recommended parts when
necessary.
15
Operation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Viking 644Viking 346Viking higher

Table of Contents