Temperature Measurement - B+B Sensors IR 8895 Operation Manual

Operation manual
Infrared-thermometer IR 8895
5.4

Temperature measurement

For measuring temperatures, hold the infrared thermometers with the opening of the infrared sensor pointing towards the object to be
measured and then press the trigger. The currently determined value of temperature appears on the LC-Display [3].
If the trigger is released now, the determined temperature value [3] shall be displayed for approximately 10 seconds. During this period,
the sign „Hold" [8] appears on the display. After this, the device turns off by itself to save on the battery power.
To localise the hottest point on the object to be measured, the infrared thermometer 8895 can be pointed towards any point lying outside
the measuring range and then, with the trigger in pressed condition, the desired range is to be scanned with zigzag movements till the
hottest point is located. Make sure that the measured object is not smaller than the measuring spot size for a given distance!
5.5 Changeover from °C to °F
You can choose the temperature values to be shown in either degree Celsius (°C) or degree Fahrenheit (°F). Press the changeover key
[A] with trigger in pressed condition. The device shows the measured value in the desired measurement units and the unit is indicated by
the symbols °C [1] or °F [2]
Technical changes reserved
0141 0316-190 30.11.2021
KEY
LASER
TRIGGER
KEY
°C / °F
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 8316-50 | info@bb-sensors.com | bb-sensors.com
7 / 12