Mainstreet Equipment 541FF40N User Manual page 10

• Connect the gas supply directly to the 3/4" male NPT connector located near the lower left rear corner of the
fryer. When tightening the supply pipe, be sure to hold the mating connector extending from the unit securely
with a wrench. This will prevent any damage or distortion to the internal piping and controls of the unit.
Checking For Gas Leaks: Using a gas leak detector or a soapy water solution is recommended for locating gas
leaks. Matches, candle flame, or other sources of ignition shall not be used for this purpose. Check entire piping
system including the internal piping and Pipe Union inside of the fryer for leaks. DO NOT use an open flame to
check for leaks. Check all gas piping for leaks with a soap and water solution before operating the unit.
• After connecting the gas supply, check again that the fryer is level. Use a long spirit level four ways; across the
front and rear of the fry pot, and along each edge.
Do not restrict the flow of gas. Use only commercially approved gas appliance connectors OR Flexible Hoses!
Non-commercial connectors or Flexible hoses will void your warranty.
10
WARNING
NOTICE
User Manual
Mainstreet Equipment