Table of Contents
Advertisement
●Quick Operation Guide
CLOCK SETTING
1. Press & hold the [TIME] button until hours flashing, then rotate
the [TUNING] knob to adjust the hour.
2. Press the [TIME] button, and then rotate the [TUNING] knob to
adjust minute while the minute is flashing.
3. Press the [TIME] button to confirm the setting.
I
※
f the [TIME] button has not been pressed again within 3 seconds,
the unit will automatically confirm the setting.
ALARM TIME SETTING
The Setup method is basically the same as setting the normal time
method, but you also need to select the automatic shutdown time
after the alarm:
1.
Press & hold the [ALARM] button until hours flashing in
the upper right corner, then rotate the [TUNING] knob to adjust
the
hours；
Press the [ALARM] button, and then rotate the [TUNING]
2.
knob to adjust the minute while minutes
3.
Press the [ALARM] button again and notice "30" shows on
display then rotate the [TUNING] knob to select 1 ~ 90 minutes
to set the auto alarm off
4.
Press the [ALARM] button again to confirm.
※ You
can
press
activate/deactivate the alarm by buzzer / radio
TUNE INTO STATIONS
1. Press the [POWER] button to turn on the radio;
2.
Select your desired band by
3. Rotate the [TUNING] button to search for stations
the numeric keys [0] - [9] to enter the station frequency
Notes:
In case of receiving FM/ SW broadcasting, fully extend the
telescopic antenna for a better reception. When receiving MW (LW)
broadcasting, please rotate the radio or change it's location to
(Refer to 12)
(R
efer to 13) )
timer；
[ALARM]
the
(Refer to 8 )
pressing the [BAND]
5
www.tecsunradios.com.au
flashing.；
button
repeatedly
respectively
button;
OR Press
directly.
to
Advertisement
Table of Contents
