Preparation And Installation; Remove Old Thermostat - Prostat OEM Series Installer Manual

Non-programmable thermostats
Hide thumbs Also See for OEM Series:
Table of Contents

Advertisement

4 Preparation and Installation

• Proper installation of the thermostat will be accomplished by following
these step by step instructions. If you are unsure about any of these steps,
call a qualified technician for assistance.
• These tools will be required:
• Make sure your Heater/Air Conditioner (Heat Pump for PSP2100) is working
properly before beginning installation of the thermostat.
• Carefully unpack the thermostat. Save the screws and instructions.
• Turn off the power to the Heating/Air Conditioning (or Heat Pump for
PSP2100) system at the main fuse panel. Most residential systems have a
separate breaker for disconnecting power to the furnace.
Remove & Replace Old Thermostat
• Remove the cover of the old thermostat. If it does not come off easily check
for screws.
• Loosen the screws holding the thermostat base or subbase to the wall, and
lift away.
• Disconnect the wires from the old thermostat. Tape the ends of the wires as
you disconnect them, and mark them with the letter of the terminal for easy
reconnection to the new thermostat.
• Keep the old thermostat for reference purposes, until your new thermostat
is functioning properly.
Installer Guide
Flat Blade
Screwdriver
10
Wire Cutter
& Stripper

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OEM Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Psp1100Psp2100Psp1152Psp2152

Table of Contents

Save PDF