New Holland T6.140 Service Manual page 69

WARNING
43.
Crushing hazard!
The wheels on this vehicle are very heavy. Al-
ways use a wheel remover or chain hoists to
remove and install the wheels. Use an assis-
tant as required.
Failure to comply could result in death or seri-
ous injury.
Install the front wheels.
44. Using suitable lifting equipment install the front
weights on the weight carrier.
45. Install the front weight retaining clamps.
Next operation:
Install the selective catalytic reduction (SCR) coolant control valve, for further information refer to Coolant control
valve - Install (10.500)
Next operation:
Install the selective catalytic reduction (SCR) muffler, for further information refer to Selective Catalytic Reduction
(SCR) muffler and catalyst - Install (10.500)
Next operation:
Fill the engine coolant system, for further information refer to Engine cooling system - Filling (10.400)
Next operation:
Recharge the A/C system, for further information refer to Air conditioning - Charging (50.200)
Next operation:
Connect the battery, for further information refer to Battery - Connect (55.302)
Next operation:
Bleed the brakes, for further information refer to Hydraulic service brakes - Bleed (33.202)
Next operation:
Calibrate front suspension. For further information refer to Electronic module Central Control Unit (CCU) - H1 -
Calibration procedures (55.640)
Engine - Engine and crankcase
W0149A
47665870 27/03/2014
10.1 [10.001] / 37
44
BAIL07APH064AVA
45
BAIL07APH062AVA
46
BAIL07APH063AVA