U-Line H-9394 Manual

H-9394
PAIL BLANKET
HEATER
1. Clean surfaces daily of all dirt and debris with warm
water and mild soap and then inspect for rips, tears
or holes of any kind. Ensure work area is free of
sharp objects to prevent tearing.
2. Ensure that the side with the straps (cold side) is
facing away from the surface requiring heat.
3. Safely connect the power cord to the power source.
CAUTION! Always use a ground fault protection
device. Never connect to a power supply that
has a higher voltage than listed on the cord
tag. (See Figure 1)
Figure 1
DO NOT REMOVE THIS TAG
MODEL VOLTS
XXXXXXXXXXXX XXX V
Part # XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
CAUTION: A GROUND FAULT PROTECTION DEVICE MUST BE USED
WITH THIS HEATING DEVICE
PAGE 1 OF 6
1-800-295-5510
uline.com
HERTZ PHASE WATTS AMPS OHMS DATE CODE
MMYY
XXXX XXXXXX XXX XXX XXX
REVX

OPERATION

WARNING! Do not submerge pail blanket
heater in liquids. Product is liquid-resistant but
not liquid-proof.
• Never pull, drag or lift product by the power
cord.
• Never connect to power when product is
folded up.
• Unit is designed to operate in most
environmental conditions without additional
insulation. Do not cover the product.
• Do not place heavy objects or walk on the
product.
4. Prepare for storage by removing all debris that may
pierce the outer shell. If possible, avoid folding the
product. If folding is necessary, follow the Folding
Instructions on page 2.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
0121 IH-9394