Offset X
Offset Y
3
3-10
Settings Menu
-50.0 - 0.0 - +50.0 mm (in increments of 0.5 mm)
This setting sets the offset position in mm. The settings can be set
between -50.0 mm (-2.00 inch) to +50.0 mm (+2.00 inch) in increments of
0.5 mm (0.01 inch).
The print position is adjusted in the vertical or horizontal direction only to
the value specified in the setting value.
You can increase or decrease the setting in increments of 0.5 mm (0.01
inch) to adjust the print position as described below.
Offset X:
Increasing the setting value moves the image in the X
direction on the paper. Decreasing the setting value moves
the image in the X direction on the paper.
Offset Y:
Increasing the setting value moves the image in the Y
direction on the paper. Decreasing the setting value moves
the image in the Y direction on the paper.
ABC
DEF
Adjust using
X/Y-Adjustment
IMPORTANT
• Please note that if the print position is adjusted to place
print data outside the valid print area, the portion outside
the valid print area will not be printed.
NOTE
• Pressing [
(0.01 inch) each time the key is pressed. Pressing [
decreases the value by 0.5 mm (0.01 inch) each time.
Holding down either [
up the value alteration.
Area adjusted using
X-Adjustment
[+]
X
Y
Y
ABC
] increases the setting value by 0.5 mm
] or [
] continuously speeds
X
DEF
]