Table of Contents
Advertisement
INSTRUCTIONS FOR USE
Turn the knob to position "0". This control stops the power supply completely
4.4
Emptying the tank
To perform this operation, open the drain tap (lever in vertical position) which can only be reached from the
door of the cabinet underneath the appliance
Note
It is advisable to perform this operation using water that is not excessively hot
4.5
Safety thermostat
The appliance is equipped with a safety thermostat that cuts off the power supply to the heating element if
the temperature of the heating element rises above 180°C. In the event of dry operation, the thermostat is
triggered after a few seconds. To restore operation, simply remove the threaded nut on the front panel of the
appliance and use a screwdriver to press the red button on the thermostat for a few seconds. If the problem
occurs again, even if the tank is full of water, call the assistance service.
4.6
Pasta cooker with automatic loading
If the probe does not detect water in the tank, the system resets the correct level and after 15 sec. disables
the heating element: an alarm is signalled by the red indicator light flashing. When the probe detects water
again, the heating element is immediately activated and after 3 sec. automatic refilling is interrupted. The
system monitors the filling phase through a TIME-OUT.
· Slow refilling button
When the "slow refilling button" is active, the system fills the tank slowly to prevent possible foaming
· Level button
The "level button" defines the level of water in the tank: high level for cooking pasta, low level for steaming
Warning
Keep the level sensor clean
Translation of the original instructions
17
Advertisement
Table of Contents
