Setup Menu - pagertec Matrix Stand Alone Manual

SETUP MENU

To enter programming mode, press the "SETUP" button on the transmitter and enter the
passcode "1357" followed by "Enter". If the password is accepted, the display will show the first
menu option which is Auto Message (Use the "#" & "*" key to scroll through the different menu
options or press "CANCEL" to exit the system programming menu.)
Auto Message:
This feature allows for a message to be pre-set and input. sent to a pager every time it is paged.
Base ID:
With this feature, you can have the option of changing your Transmitter Base ID. To change the
Base ID of your transmitter follow the below instructions:
At the "Base ID" menu press the "ENTER" key
Select a 3-digit Base ID number ranging from 001 - 199 then press "ENTER" key on the option
you wish to select.A transmitter that has successfully received the change of Base ID command
will automatically be set and brought back to the programming menu showing the new Base ID
and the Base ID Number.
At this point, the transmitter should be programmed to the Base ID you selected.
Press "Cancel" key to exit, and return to the main menu.
(note: our default transmitter Base ID: is 019)
​ B PS (Baud Rate):
With this feature, you can have the option of changing your pagers BPS of the Transmitter .
(Baud Rate) To change the BPS of your Transmitter follow the below instructions:
1. At the "Baudrate" menu press the "ENTER" key
2. Use the "#" or "*" key to select bps >512 OR >1200
3. Press "ENTER" on the option you wish to select
At this point, the transmitter should be programmed to the BPS you selected.
Press "Cancel" key to exit, and return to the main menu.
​
( Note: our default BPS for pagers is >512)