Manual VIPA System 300S SPEED7
Cabling
Overview
The Co Power Supply is exclusively delivered with CageClamp contacts.
Here the DC 24V power supply may be connected.
Danger!
• Before installation or overhauling, the power supplies must be
• Installation and modifications only by properly trained personnel!
CageClamp
For the cabling gray connectors with CageClamp technology are used.
technology (gray)
You may connect wires with a cross-section of 0.08mm
1
can use flexible wires without end case as well as stiff wires.
You fix the conductors to the CageClamps like this:
2
The picture on the left side shows the cabling step by step from top view.
• To conduct a wire you plug a fitting screwdriver obliquely into the
• To open the contact spring you have to push the screwdriver in the
3
• Insert the insulation striped wire into the round opening. You may use
• By removing the screwdriver the wire is connected safely with the plug
HB140E - PS - RE_307-1FB70 - Rev. 13/43
All manuals and user guides at all-guides.com
Chapter 1 Assembly and installation guidelines
disconnected from voltage (pull the plug or remove the fuse)!
[1] Rectangular opening for screwdriver
1
2
[2] Round opening for wires
rectangular opening like shown in the picture.
opposite direction and hold it.
wires with a cross-section from 0.08mm
connector via a spring.
2
to 2.5mm
2
2
to 2.5mm
.
2
. You
1-7