Mts - Sanyo AVM-27D6 Instruction Manual

SOUND ADJUSTMENT

MTS

1) USING MTS BUTTON : METHOD 1
Your TV set incorporates an MTS (Multichannel Television Sound) decoder to receive stereo
broadcasts and any accompanying SAP (Second Audio Program), such as a bilingual
broadcast.
1. Press the MTS button
Whenever this button is pressed, the reception mode will be changed as follows.
STEREO SAP
The " ", " " symbols indicate that MTS mode is being broadcasted.
STEREO symbol (RED color)
SAP symbol (RED color)
When the power is switched on or channel is changed, the "
automatically displayed, depending on the current broadcast.
TV 2
NOTES
If the received signal is weak, noise may be heard.
In such a case, press MTS button to set to the MONO mode for better sound reception.
If the received SAP signal is weak, the SAP will not be heard.
Even if both STEREO and SAP broadcasts are received, both broadcasts cannot be
heard at the same time.
Transmission of CABLE TV signals may differ from off-air TV broadcasts.
26
All manuals and user guides at all-guides.com
MONO
", " " symbols are
SOUND ADJUSTMENT
MTS
2) USING SOUND MENU : METHOD 2
1 1
1 1
MENU
PICTURE
SOUND
TIME
SET UP
FUNCTION
SEL. + ENTER
2 2
2 2
SOUND
* 50 BASS
* 50 TREBLE
* 00 BALANCE
* MTS : STEREO
ON AIR
SEL. + SET
3 3
3 3
Press the VOL + / - buttons.
Whenever this button is pressed, the mode will be changed as follows.
STEREO SAP
SOUND
* 50 BASS
* 50 TREBLE
* 00 BALANCE
* MTS : STEREO
ON AIR
SEL. + SET
27
Press the MENU button. Move the
cursor to SOUND by pressing the CH
/ buttons and press the VOL +
button.
Move the cursor to MTS by pressing the
CH / buttons.
MONO
SOUND
* 50 BASS
* 50 TREBLE
* 00 BALANCE
* MTS : SAP
ON AIR
SEL. + SET