Table of Contents
Advertisement
NL Softening System
Remark: Set the device to the
determined water hardness.
→ "Setting water softening",
Page 24
With a water hardness of 0 - 6 °dH
you do not need to use softening
salt for dishwashers and you can
switch off the water softening.
→ "Switch off water softening",
Page 25
Set water softening
Set the appliance to the water
hardness.
Determine the water hardness and
1.
the desired setpoint.
→ "Overview of the water hard-
health settings", page 23
on
to press.
2.
Approx. 3 seconds on
3.
to access the basic settings.
a The display shows Hxx.
a The display shows
to give.
Press as many times until
4.
the desired water hardness has
been set.
The factory setting is H04.
To save the settings, press for
5.
approx. 3 seconds.
softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the start of the
programme. The required amount of
softening salt depends on the water
hardness. The higher the
24
water hardness, the greater the
amount of softening salt required.
PAY ATTENTION!
s Dishwasher detergent can damage the water
damage hardening.
The reservoir of the softener
▶
Only fill the water supply with
special salt for dishwashers.
s The rinse aid container can be
corrode softening salt for
dishwashers.
To ensure that
▶
spills out of the softening salt
from the rinse aid container, the
softening salt must be filled into
the water softening salt
reservoir immediately before the
program starts.
Busy-
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
Advertisement
Table of Contents
