Pictgraph Illustration And Explanation - Hitachi Koki VB 16Y Handling Instructions Manual

3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be kept
as short as practicable.
CAUTION:
Damaged cord must be replaced or repaired.
4. Preparation and
environment.
Check and confirm if the workplace is in proper
conditions as mentioned in the general operational
precautions item 1.
5. For safety sake, use the provided Allen key to make
absolutely sure that the hexagon socket bolt is
securely clamped. Use of the unit with the bolt in a
loosely clamped condition can result in damage to
the unit and cutter as well as accidents.
PICTGRAPH ILLUSTRATION AND
EXPLANATION
Read handling
instructions before use.
Begin operation only after
ensuring that there are no
people within the turning range
of the material to be bent.
(Returning Halfway)
1 Select RETURN with the dial.
2 Pull the triger.
confirmation of working
Do not this electric
power tools in wet
wether conditions.
Never bring your hand
close to the cutter
during operation.
6. Confirm that the cutter is in sharp condition.
Make certain that the cutter is in a sharp condition.
Continued use of a worn out and deformed cutter with
dull edges results in damage to the unit and cutter as
well as accidents.
7. Check plug receptacle.
If a receptacle jounces or a plug comes out easily when
a power cord is plugged in, the receptacle needs to
be repaired. Consult the nearest electric service station
for repair. Continued use of the defective receptacle
can result in overheating and accidents.
If the switch is turned off and then
immediately turned on again, the motor
may not start. Wait for at least one full
second before attempting to turn the motor
on again after it has been switched off.
Avoid any work exceeding
the maximum capacities.
(Rebar diameter ø16 mm.)
(Selecting the rebar size)
Select the rebar size and the
bending angle.
ø12
ø10
ø16
English
36