Table of Contents
Advertisement
CHANGE THE DISPLAYED UNIT (CM / INCH)
S
1.
Press "S" key until the display show "S--" to enter the setup menu.
2.
Press up key until the display shows "UNT".
3.
Press "1", and the display will show alternately as "Unt" and the desktop current height
1
value in "cm".
S
4.
Press "S" key to save the unit as cm.
5.
Press "2", and the display will show alternately as "Unt" and the desktop current height
2
value by "inch". Press the "S" key to save the unit as inch.
AMEND THE DESKTOP HEIGHT DISPLAYED
S
1.
Press "S" key till the display show "A--".
2.
Briefly press the "Up" or "Down" key, until the display shows alternately as "End" and
current height. (At this point, the units display mm or inch).
3.
Press "1", "2", "3" to choose the first, second and the third number each click will
2 3
1
increase one value.
S
4.
Press "S" key to confirm.
NOTE: The function enables you to change the height shows on the display based on the actual
measurement.
PLUG DETECTION
The function can detect whether the motors are connected properly.
1.
Once the display shows "E-3" and "RES", it means the motors have failed to connect
E-3
with the control unit.
2.
Please unplug the main cable, check all connections, and make sure all cables are
connected properly then plug the main cable in.
3.
Follow the "Manual Reset Progress" to reset system.
USAGE INSTRUCTION |
13
Advertisement
Table of Contents
