Setup And Operation; Specifications; Troubleshooting - Qtx QTFX-400 User Manual

Setup and Operation

The QTFX-B2 requires bubble fluid to produce the effect.
It is recommended to use qtx bubble fluid for best results (160.574UK, 160.575UK)
For bubbles that glow in UV light, qtx UV bubble fluid may be used (160.576UK, 160.577UK)
A chart for recommended fluids is included further along in this document
• Position the QTFX-B2 on a stable surface or mount upright using the integral bracket
• Pour bubble fluid directly into the front open tank, taking care not to spill on electrical
parts of the machine
• Connect the IEC mains plug
• Switch power on at the rear panel to begin producing bubbles
• Switch off to stop producing bubbles
• Disconnect from mains when usage is finished
• Empty remaining bubble fluid back into container or dispose as appropriate
• Rinse fluid tray with water and wipe clean before next use

Specifications

Power supply
Power consumption
RPM
Fluid capacity
Dimensions
Weight

Troubleshooting

Power switch not lit when switched on
No bubbles output
This product is classed as Electrical or Electronic equipment and should not be disposed with other household or
commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines
Errors and omissions excepted.
Copyright© 2021 AVSL Group Ltd, Unit 2 Bridgewater Park,
Taylor Road, Trafford Park, Manchester. M41 7JQ.
www.avsl.com
230Vac, 50Hz
40W
20
0.6l
290 x 240 x 220mm
2.0kg
Check mains is correct voltage & switched on
Check IEC lead and mains inlet fuse
Check fluid tank is filled enough to cover wands
Ensure rear fan grille is not obstructed
AVSL (Europe) Ltd, Unit 3D North Point House,
North Point Bus. Park, New Mallow Road, Cork, Ireland.
160.563UK Manual