Table of Contents
Advertisement
Quick Links
• Version 2.20 or later is required for the PIA4800 series Power Supply Controller.
1. Control Parameters
The following parameters can be controlled.
KIKUSUI ELECTRONICS CORP.
C o n n e c t ion to the PWR Series
If you are using an earlier version, you need to update the firmware. For details,
contact your Kikusui agent.
You can check the PIA4800 series version using *IDN?. For detail, see "Device
Messages"
• Output voltage setting
• Output current setting
• Output voltage readback
• Output current readback
• Output power readback
• Overvoltage protection setting
• Overcurrent protection setting
• Output ON/OFF
• POWER switch OFF
• C.V mode monitoring
• C.C mode monitoring
• Power limit operation monitoring
• Output ON/OFF monitoring
• Overvoltage protection start-up monitoring
• Overcurrent protection start-up monitoring
• Overpower protection start-up monitoring
• Overheat monitoring
1
Advertisement
Table of Contents
Related Manuals for Kikusui PIA4800 Series
Summary of Contents for Kikusui PIA4800 Series
- Page 1 C o n n e c t ion to the PWR Series • Version 2.20 or later is required for the PIA4800 series Power Supply Controller. If you are using an earlier version, you need to update the firmware. For details, contact your Kikusui agent.
- Page 2 (A WG22) , within 200 m or stranded: 0.20 mm (A WG24) , within 20 m φ • Flat-blade screwdriver (axis diameter: 3, end width: 2.6 mm) • Wire stripper suitable for the wires described above. 2 KIKUSUI ELECTRONICS CORP.
- Page 3 （ ） PIA4800 SERIES Wiring the TP-BUS connector When using the PIA4850, the PIA4850 should be connected at the end of the b us. Rear panel TP-BUS connector Chec k that the POWER switch of all deveces to be connected are turned off.
- Page 4 SERIES（ PWR） Installing a TP-BUS core Attach a TP-BUS core to the power supply controller (excluding the PIA4850) Unloc k the core(provided with PIA4800 series) and open it. Unlock the core and open it. Wind the twisted-pair wire which is connected to the power supply controller for once around on the half core.
- Page 5 （ ） PIA4800 SERIES 3. Preparations for Starting Control Settings on the Termination (TERMIN) T urn on the termination (TERMN) on the devices at each end of the bus. The PIA4850 is always turned on. Wire the PIA4850 at the end of the bus.
- Page 6 If you e xit from the node address setting before turning of f the PO WER switch, the setting is cancelled. Lik ewise, set the node address of all PWR seriess that are to be connected. 4. Commands F or the commands, see “Device Messages” of Connecting & Programming guide. 6 KIKUSUI ELECTRONICS CORP.
Need help?
Do you have a question about the PIA4800 Series and is the answer not in the manual?
Questions and answers