BWT BC 50 Manual page 12

- If the liner is brittle, damaged or wrinkled, contact a qualified professional to perform
the necessary repairs or perform a liner replacement prior to using the pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the
pool vacuum into the water.
OPERATION
WARNING!
Make sure the pool vacuum is off

Do not use the pool vacuum if any damage is detected.

Oil stain could occur due to possible leakage of lubricants applied to the

O-ring.
Do not operate this pool vacuum if there are people/pets present in the

water.
Make sure the pool vacuum is fully immersed in the pool before initiating

operation. The minimum water level required to operate the pool vacuum
must reach above the power ON/OFF switch of the pool vacuum when it
is held in a vertical position. Operating the pool vacuum when it is not
immersed correctly could damage the unit and void the warranty.
DO NOT use the pool vacuum without an intact filter cone in place. Using

your pool vacuum without an intact filter cone in place will VOID your
warranty.
DO NOT cover the side slot of the vacuum during operation. The

impeller /motor may be damaged as a result.
DO NOT leave the pool vacuum in the water when it is not in use.

1) B ring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and turn the power ON/FF switch to the ON position to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed into
the pool/spa. Otherwise it may bend the pole connector and damage it during the process.
2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing it
downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the handle / pole connector and draining holes inside the handle chamber
on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed
from the pool/spa. Otherwise, the pole connector may be bent and damage the pool
vacuum in the process
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
MAINTENANCE & CLEANING 11 2021/02 : A