Telescopic Pole (Not Included) Assembly; Pool Preparation P - BWT BC 50 Manual

NOTE: To replace the brushes on the suction head, lift the end and pull it out to make
space for a new one.
WARNING! For vinyl liner and fibreglass pools/spa, it is recommended to keep the
brushes on the suction head to avoid damaging the pool/spa.

Telescopic pole (not included) assembly

Insert the end (with one side pin) of the pole connector into the pool vacuum as shown
until its single side pin is secured to the handle's locking hole on the rear body. Slide the
telescopic pole into the pole connector until the side holes of the telescopic pole are
secured to the side pins of the pole connector.
To release the telescopic pole, press down on the two side pins simultaneously and pull
out the pole.
Pool Preparation
- If there are stones, roots or metal corrosion in contact with the underside of the liner,
discard them prior to using the pool vacuum. If necessary, seek assistance from a
qualified professional.
MAINTENANCE & CLEANING 10 2021/02 : A