Troubleshooting - Trust 750 LCD POWERCAM ZOOM Instruction Manual

14

Troubleshooting

Method
1. Read the solutions given below.
2. Check for up-to-date FAQ's, drivers and instruction
manuals on the Internet (www.trust.com/13404).
Problem Cause
Windows does The computer's USB
not detect a new port does not work.
device after
connecting the
camera.
The camera has not
been connected to a
USB port.
The camera has been
connected to a USB
hub which does not
have a power supply.
The error The camera has not
been connected to a
message
USB port.
'Capture device
was not detected' The camera has been
connected to a USB
is displayed.
hub which does not
have a power supply.
The TRUST 750 The camera has been
connected to a USB
LCD
hub which does not
POWERC@M
have a power supply.
ZOOM is marked
with an
exclamation mark
'!' in the Device
Manager.
There is a conflict
The TRUST 750
LCD between the camera
and the TV card.
POWERC@M
ZOOM does not
work in
combination with
the TV/capture
card.
The batteries have
The camera does
been inserted
not do anything.
incorrectly.
Camera is still
connected to your
computer.
The camera is turned
off or is in the sleep
setting.
TRUST 750 LCD POWERC@M ZOOM
!
Possible solution
Check the settings for your
USB port. For more
information, see
www.trust.com/customercare/
help/usb
Connect the camera to a USB
port
Connect the camera to a USB
hub which has a power supply
or to a USB port on your
computer.
Connect the camera to a USB
port.
Connect the camera to a USB
hub which has a power supply
or to a USB port on your
computer.
Connect the camera to a USB
hub which has a power supply
or to a USB port on your
computer.
Carry out the following.
1) Remove the TV Capture
card.
2) Install the TRUST 750 LCD
POWERC@M ZOOM.
3) Install the TV capture card.
Reinsert the batteries (see
chapter 4).
Disconnect the USB cable.
The camera cannot be
operated when it is connected
to a computer.
Turn the camera on or take it
out of the sleep setting by
pressing the LCD button (2,
figure 2).
25
U K