Philips HeartStart Instructions For Use Manual page 56

TROUBLESHOOTING WHILE THE HEARTSTART IS NOT IN USE
(green Ready light is not on)
behavior
chirps or • The battery power is low or the
i-button flashes
• The defibrillator may have been
• The training pads cartridge has been
• The defibrillator has been stored
• The defibrillator has detected an
no chirping and/or • The battery is missing or completely
i-button does not flash
• The defibrillator may have been
possible cause
SMART Pads cartridge needs to be
replaced.
turned off without a pads cartridge
installed, or the installed pads
cartridge may not have its hard
cover in place.
left in the defibrillator.
outside the recommended
temperature range.
error during a self-test or cannot
perform a self-test, or the Shock
button is damaged.
depleted.
physically damaged.
recommended action
• Press the blue i-button. Replace
the battery or pads cartridge if
instructed.
• Make sure the pads cartridge is
properly installed with the hard
cover in place. (See Chapter 5,
"Maintaining the HeartStart," for
directions on installing the pads
cartridge.)
• Remove the training pads cartridge
and replace it with an Adult or
Infant/Child Pads Cartridge.
• Remove the battery for five
seconds then reinstall it to start
the battery insertion self-test. If it
fails, insert a new battery to repeat
the test. If it fails again, do not use
the defibrillator. If it passes, store
the defibrillator within the
recommended temperature range.
• Contact Philips for service if
needed.
Remove the battery for five seconds
then reinstall it to start the battery
insertion self-test. If it fails, insert a
new battery and repeat the test. If it
fails again, do not use the defibrillator.
Contact Philips for service.
G
G-4