Canon Printer User Manual page 24

Media Configuration Tool Guide
Media Thickness
Standard
Thin
6. From the Vacuum Strength list set the Vacuum Strength when printing a media type to be
added.
The following settings are available for Vacuum Strength.
Vacuum Strength
Strongest
Strong
Standard
Weak
7. From the Skew Error Detection Standard Values list set the standard which will cause a
media slant detection error in the printer.
The following settings are available for Skew Error Detection Standard Values.
Skew Error Detection
Standard Values
1 mm, 2 mm, 3 mm, 4 mm,
5 mm
8. Set the auto cut speed for media to be added from the Cut Speed list.
The following settings are available for Cut Speed.
Cut Speed
Standard
Fast
9. Set the amount of media to purge after cutting the media type to be added in the Media
Feed Amount After Cutting list.
The following setting are available for Media Feed Amount After Cutting.
Media Feed Amount After
Cutting
No
Chapter 4 Adding Media Types
Setting
For media that is a standard thickness
and has no problem printing.
Select this when the media set is thin, or
when the image is adversely affected.
Setting
For media that does not settle even
when set to Strong.
For media that does not settle properly
because it curls.
For media that has no problems when
printed.
For thin media, or when the image on
the media is adversely affected.
Setting
Reduce the value for media used for
documents where the precision rate is
important and for media where strict
detection of slants is required. Increase
the value for media that does not slant
much and for media that is used for
documents that allow for a degree of
slant.
Setting
For media that has no problem with
cutting.
For media that has problems, such as
inaccurate cutting with the Standard
setting.
Setting
Does not purge media after cutting.
4-7