Advertisement
AUDIO AND VIDEO DOOR ENTRY SYSTEM - WIRELESS MODULE
DESCRIPTION OF THE MODULE
Description of the CD-NEXA/BT module
Description of the SW1 DIP switch:
For the CD-NEXA/BT module to operate properly, keep DIP switches 1 and 2 in the OFF position.
1
2
Description of the Nexa Bus link
The Nexa Bus link connector is located at the bottom of the CD-NEXA/BT
Connect the cable supplied with the module to connect with other modules by means of the Nexa
bus, thereby providing the system with a wireless configuration interface.
The following modules allow a wireless configuration:
N3403/AL:
Display module.
ð
N3301/AL:
Access control module and coded panel
ð
Description of the status LEDs:
Waiting for connection to be established.
INSTALLATION OF THE MODULE
Positioning the CD-NEXA/BT module:
Position the CD-NEXA/BT module at the back of the embedding box, connect the link hose to the
Nexa bus as shown in the drawing, then connect the other end of the hose to any of the free
connectors of the bus of the N3403/AL, N3301/AL or EL3002 modules (if any).
Important:
connector:
Status
In
standby.
Connection established.
Data transmission.
For proper operation, avoid placing the module on a metal base
SW1 DIP
switch.
CN1 connector (reserved for internal use).
Red LED indicating data communication.
Green LED indicating connection status.
Nexa bus connector.
module.
.
Green LED
Blinking
Fixed
Fixed
Red LED
Off
Blinking
.
2
Off
Off
Off
Advertisement
