NEC N8154-24 User Manual page 56

24.
Connect the power cable, SAS/SATA cables, and SGPIO cable to the rear of the 2.5-inch disk cage,
as shown in the figure below.
– SGPIO cable
Use the SGPIO cable to connect the SGPIO connector (J3) on the back of the 2.5-inch disk cage to
the SGPIO A connector at the bottom of the motherboard.
– Power cable
Connect the server power cable P12 to the power connector on the back of the 2.5-inch disk cage
that is further away from you (CN2), and connect the server power cable P11 to the power
connector on the back of the 2.5-inch disk cage that is closer to you (CN1).
11