Table of Contents
Advertisement
1-2. Total Adjustments
The adjustments are required when the unit is
overhauled.
Be sure to perform the adjustments from the
beginning to the last. When performing some
adjustments separately, perform the adjust-
ments following the flowchart shown in the item
1-3.
<Flowchart>
START
1-2-1. Sub Carrier Frequency Adjustment
1-2-2. R - Y Carrier Balance Adjustment
1-2-3. B - Y Carrier Balance Adjustment
1-2-4. REF G Adjustment
1-2-5. REF R, REF B Adjustment
1-2-6. B - Y Level Adjustment
1-2-7. Color Adjustment
When performing the adjustments;
1. Set SA01 on the DSP PC board to ADJ side
and enter the unit to the adjusting mode.
2. Push the MENU button (on the front panel)
and select the adjusting item.
Adjust the controls and electrical controls on
each PC board. The electrical controls are
adjusted by the DATA buttons (on the front
panel).
SA01:
ADJ
1-2-8. Burst Level Adjustment
1-2-9. ABB1 Adjustment
1-2-10. ABB2 Adjustment
1-2-11. Area Size Adjustment
1-2-12. Preset Adjustment
1-2-13. Setting at Shipping
2-4
END
SA01:
ADJ
SA01:
NORM
Advertisement
Table of Contents
