Table of Contents
Advertisement
must be performed and, if necessary, documented according to the required pro-
cedures and time intervals.
7.5
Readjust adjustment gib
If the press ram has insufficient or too much play, i.e. is either jammed or cannot
move sideways the adjustment gib must be readjusted.
Loosen the three nuts on the right
side of the guide unit (Fig. 15,
Pos. 1), but do not completely
remove.
By turning in of the threaded pins
straighten adjustment gib evenly,
to ensure that it has the same play
at the top and at the bottom (Fig.
15, Pos. 2).
Retighten the three nuts (Fig. 15,
Pos. 1).
The adjustment gib must not be adjusted too close because otherwise the press
will no longer reach its specific press force and increased wear will happen!
NOTE
Version 1.6
GECHTER
– Pneumatic toggle presses
20 kN KHKP, 60 kN KHKP
Fig. 15 Readjust adjustment gib
– 39 / 49 –
Pos. 1 Adjustment gib of screws
Pos. 2 Adjustment gib
08/2009
(1)
(2)
Advertisement
Table of Contents
