Table of Contents
Advertisement
Remove the three or four clamping
screws of the clamping of the
guide unit (Fig. 8, Pos. 1) with a
box wrench but do not completely
remove.
Loosen the clamping screw on the
threaded spindle (Fig. 8, Pos. 2)
with a hexagon socket wrench but
do not completely remove.
Set the guide unit (Fig. 9, Pos. 2)
with the crank handle, the hand
wheel or the ratchet (Fig. 9, Pos.
1) up or down to the required
height.
Tighten the clamping screws of the
clamping of the guide unit (Fig. 8,
Pos. 1) properly. Pay attention to
the preset tightening torque (→
page 29, Tab. 7) when doing so.
Remove the thread play from the
threaded spindle. Protect the
threaded spindle with the clamping
screw (Fig. 8, Pos. 2) against
twist.
Version 1.6
GECHTER
– Pneumatic toggle presses
20 kN KHKP, 60 kN KHKP
Fig. 8 Loosen clamping screws
(2)
Fig. 9 Adjust height
– 31 / 49 –
Pos. 1 Clamping screws of guide unit
Pos. 2 Clamping screws of threaded spindle
(1)
Pos. 1 Crank handle. Hand wheel or ratchet
Pos. 2 Guide unit
08/2009
(2)
(1)
Advertisement
Table of Contents
