Ugur UDF 3 SL Operating Manual page 47

D- USING YOUR DEEP FREEZER
Setting the Internal Temperature of your Product
UDF 5 SL
You can set the internal temperature of your product by means of a thermostat on the control panel
- There are three levels which are MIN, MID and MAX on the thermostat. (Picture 10)
When you take the thermostat switch to "MIN" position, running rate of your product will decrease and you will
get less cooling.
As you set the thermostat towards MAX position, running rate will increase and thus you will get more cooling.
Note: In UDF 5 SL model, take your product to "MID" position and run empty for 24 hours before start using it.
MID position is the mode suitable for running under many conditions
Resim 10 B
Setting the Internal Temperature of your Product
UDF 7 SL
You can set internal temperature of your product through the thermostat on the control panel:
You can set the thermostat by using a coin etc. that can enter the opening on the button (Picture 10 C)
There are 1, S and the numbers between these two on the thermostat button
Operating ratio of your product will increase as you shift the button toward the position "5" and thus you will gain more
cooling.
Operating ratio of your product will decrease as you shift the button toward the position "1" and thus you will gain less
cooling.
When you take your thermostat button to "S" position, your product will run in super cooling mode and therefore you
will gain the fastest and highest cooling.
Ex-factory thermostat setting of your product is position 3. This position is the most efficient position of the freezer in
terms of cooling and energy consumption
3
2
4
1
5
S
Internal temperature of your product can be set between -18°C and -25°C
3
2
4
1
S
PICTURE 10 C
47
EN