Advertisement
English
Fitting the Sling from a Seated Position
1
Feed the Standing Harness down the back of the
patient and position around the chest.
3
Raise and position the Standing Harness up
towards the chest. The Standing Harness is
equipped with two adjustable safety clasps.
Attach both safety clasps as shown and tighten
for comfort as appropriate (the fit should be snug
not tight).
2
Attach the leg supports to the Standing Harness
by offering the safety clasp to the retaining ring
at the bottom of the Standing Harness as shown.
The leg supports can be adjusted in length for
comfort as appropriate.
4
To attach the Standing Harness to the spreader
bar, firstly place the patient's arms through the
loop straps as shown, and attach to the spreader
bar by using the coloured loop straps. Ensure
the same colour loop is used on both straps and
hook onto the side hooks. Check both loops are
securely attached prior to use.
Oxford
Standing Harness
3
®
Advertisement
